24小时计时程序设计 山师大.doc

此程序实验成功。 #includereg51.h #define display1 0xdf #define display2 0xef #define display3 0xfb #define display4 0xf7 #define display5 0xfd #define display6 0xfe #define Uchar unsigned char Uchar a,b,c,d,sec0,sec1,min0,min1,hour0,hour1; sbit set_save=P3^2; sbit up=P1^0; sbit sel=P1^2; sbit e=P1^3; code unsigned char led[]={0x3f,0x06,0x5b,0x4f,0x66,0x6d,0x7d,0x07,0x7f,0x6f}; code unsigned char led_point[]={0x40,0x79,0x24,0x30,0x19,0x12,0x02,0x78,0x00,0x10}; void delay_ms(Uchar count); void disp_time(); void key_scan(); void time(); void up_down(); void delay_ms(Uchar count) { Uchar i,j; do { for(i=5;i0;i--) for(j=98;j0;j--); }while(--count); } void main() {a=0;b=0;d=0;sec0=0;sec1=0;min0=0;min1=0;hour0=0;hour1=0; TMOD=0x01; TH0=0x3c; TL0=0xb0; EA=1; EX0=1; ET0=1; IT0=1; TR0=1; while(1) { if(b==1){key_scan();} disp_time(); } } void Timerupt() interrupt 1 { a=a+1; TH0=0x3c; TL0=0xb0; if(a==20){a=0;TH0=0x3c;TL0=0xb0;TF0=0; time(); } } void Interrupt() interrupt 0 { b=b+1; if(b==1){ET0=0;TR0=0;e=0;} if(b==2){e=1;b=0;d=0;TH0=0x3c;TL0=0xb0;TR0=1;ET0=1;} } void key_scan() { if(sel==0) {delay_ms(2);} if(sel==0){if(d6)d=d+1; else{d=0;} } while(!sel){disp_time();} if(d==1){ if(up==0){delay_ms(2);} if(up==0){if(hour12){hour1=hour1+1;disp_time();} else{hour1=0;disp_time();} } while(!up){disp_time();} } if(d==2){if(up==0){delay_ms(2);} if(up==0){if(hour12){if(hour09){hour0=hour0+1;disp_time();} else{hour0=0;disp_time();}} if(hour1==2){if(hour04){hour0=hour0+1;disp_time();} else{hour0=0;disp_time();}} } while(!up){disp_time();} } if(d==3){if(up==0){delay_ms(2);} if(up==0){if(min16){min1=min1+1;disp_time();} else