北京西门子s7培训资料A1482_f_02.pptVIP

Installation/Maintenance of a PLC Components for the Configuration of an S7-300 Mounting Positions for an S7-300 Configuration Expansion Capabilities for an S7-300 Installation Rules For a horizontal configuration, the CPU and power supply must be arranged on the left. For a vertical configuration, the CPU and power supply must be arranged at the bottom The following minimum clearances must be maintained: 20 mm to the right and left of the rack 40 mm above and below for a single-tier configuration and at least 80 mm between two racks The interface module always occupies the space next to the CPU There may be a maximum of eight I/O modules (signal modules, function modules, communication processors) inserted in a rack A multi-tier configuration is possible only for the CPU 314/315/316 Please ensure that there is a low resistance connection between the rail and the substructure, such as through contact washers. Installation Aids Installation Check List Installing the Rail (Part 1) Installing the Rail (Part 2) Check List for Electrical Configuration 1. Are analog signals or bus signals used? 2. Do cables with 60V exist? 3. Are inductances switched by additional contacts in the output circuit or independent of the programmable logic controller? 4. Will cables be laid outside of buildings? Wiring the Front Connector Open the front door of the signal modules ! Bring the front connector into wiring position ! Thread the strain reliever in the front connector ! Strip the insulation from the wires (6 mm length) ! Connect the wires ! Tighten the strain relief for the cable loom ! Position the front connector in the operating position ! Close the front door ! Fill out the labeling strip and insert it in the front door ! Attach the slot number to the front door ! Preparing for Operation Insert the keyswitch in the CPU ! Install the back-up battery ! if the user program is not stored in a power failure-proof way in the memory module if larger data areas must remain retentive