shock absorber abnormal structural noise.docVIP

shock absorber abnormal structural noise Abstract: In order to discover the causes of the abnormal noise of shock absorbers, it is necessary to identify the operating characteristics of the shock absorbers. A micro-process model for operation of the hydraulic shock absorber was presented. A novel concept, which describes the process of hydraulic shock absorber by dividing it into smaller steps, was proposed. The dynamic model and the differential equations were established. The results of numerical simulation agree well with data obtained from the vibrostand test, indicating that the collision between the piston and the oil, the alternation of static friction and sliding friction acted between the piston and the cylinder, and the adherence between valve plate and piston result in impact on the piston head near the top dead center and the bottom dead center. Ultimately, the impact excites the high-frequency vibration of the piston structure, which can generate the abnormal noise in the hydraulic shock absorber after its transfer. And the maximum vibration acceleration on the piston head and the abnormal noise increase with the increase of the gap between the oil and piston rod head, the maximum static friction force and the adhering function, respectively. Key words: shock absorber; abnormal noise; micro-process; clearance impact; simulation shock absorber by using strain gauge measurement methods. They also discussed the influence of adhering 1 Introduction [8]function between the valve plates and piston. ZHANG [4]Although some main noise sources in automobiles and YUinvestigated the empty travel impacts caused have been well controlled in recent years, the abnormal by the external characteristics distortion of the shock [4]noise of the automobile hydraulic shock absorber, which . A non-parameter mathematical model of the absorberreduces the quality and decreases the sales volume of shock absorber based on Bouc Wen!ˉs hysteresis model