IS8124-1SafetyofToysPart：MechanicalandPhysicalProperties(doc92)英文.docVIP

IS 8124-1 Safety of Toys Part 1: Mechanical and Physical Properties Compared with EN-71-1:1998 and ASTM F963-96a Note: The comparison below is for reference and evaluation of differences only. This document should not be used in place of the original standards and is not guaranteed to be accurate. See last page of this document for information on obtaining the actual standards. ISO 8124-1 (FINAL DRAFT) EN71-1:1998 F963-96a Notes and Comments SCOPE The requirements in this part of ISO 8124 apply to all toys, i.e. any product or material designed or clearly intended for use in play by children under 14 years of age. They are applicable to a toy as it is initially received by the consumer and, in addition, they apply after a toy is subjected to reasonably foreseeable conditions of normal use and abuse unless specifically noted otherwise. The requirements of this part of ISO 8124 specify acceptable criteria for structural characteristics of toys, such as shape, size, contour, spacing (e.g. rattles, small parts, sharp points and edges, hinge-line clearances) as well as acceptable criteria for properties peculiar to certain categories of toy (e.g. maximum kinetic energy values for non-resilient-tipped projectiles, minimum tip angles for certain ride-on toys). This part of ISO 8124 specifies requirements and test methods for toys intended for use by children in various age groups from birth to 14 years. The requirements vary according to the age group for which a particular toy is intended. The requirements for a particular age group reflect the nature of the hazards and the expected mental and/or physical abilities of the child to cope with them. This part of ISO 8124 also requires that appropriate warnings and/or instructions for use be given on certain toys or their packaging. Due to linguistic problems that may occur in different countries, the wording of these warnings and instructions is not specified but given as general information in