N1714E_01.docVIP

Ce document et toutes les informations et données quil contient sont confidentiels et sont la propriété légale de lauteur. Ils ne doivent pas être diffusés, copiés ou utilisés à quelques fins que ce soit sans accord écrit préalable. This document and any information or descriptive matter set out in it are confidential and copyright property and must not be disclosed, loaned copied or used for any purpose whatsoever without prior written permission Dieses Dokument sowie alle Informationen, die es enth?lt, sind vertraulich und somit geistiges Eigentum des Urhebers. Sie dürfen ohne vorherige schriftliche Erlaubnis weder verbreitet, zur Verfügung gestellt, kopiert noch für irgendwelche Zwecke verwendet werden. Internal designation N1714 Method of manufacture wound and cured, not laid up in mould Surface condition fairly smooth Material codes internal EP – N 1714 obsolete ISO DIN Hgw 2375 Properties As-delivered forms and references to standards for semifinished products Unit R. 242.714 Scope: Numerical values apply to specimens and tests as set forth in DIN 7735 Tensile strength B N/mm2 min. 200 1 Flexural strength bB untreated N/mm2 min. 300 Notch impact strength k mJ/mm2 Impact toughness n MJ/mm2 Compressive strength dB N/mm2 min. 150 Cleavage force N Density kg/dm3 1,7 ... 1,9 Modulus of elasticity N/mm2 approx. 18000 Coefficient of linear thermal expansion 1/K Thermal conductivity W/m·K Resistance between plugs 1010 1 1-min. test voltage at 90 2 °C: – Electrode spacing 25 mm parallel to plies kV min. 40 8 mm wall thickness ;min. 25 8 mm wall thickness 3 – Electrode spacing 3 mm perpendicular to plies kV min. 30 3 Dielectric loss factor tan max. 0,05 4 Dielectric constant r Tracking resistance, method KC KC 180 Temperature limit °C 130 softens around 100 °C Water absorption slight Composition Epoxy resin + glass fibre woven fabric Processing and application Standards and specifications Tes