第三讲GMS上机实习操作.pptVIP

GMS建模操作演示 中国地质大学 武汉 环境学院 2012.8 GMS 中MODFLOW的使用 1 Getting Started 2 Required Modules/Interfaces 选择需要的模块（ File | Register ） ? Grid ? Geostatistics ? Map ? MODFLOW 3 Importing the Background Image输入背景图 1）可以识别的文件包括：jpg、tif、shp、dxf、grd等 2）图片定坐标： 4 Defining the Units定义单位 Select the Edit | Units command 5MODFLOW - Conceptual Model Approach 1）. Switch to the Map module . 2）. Right click on the Map Data folder in the Data Tree and select the New Conceptual Model command. 3）.Enter the name. For the Model, select MODFLOW. 4）. Click OK. 5）. Right click on the conceptual model and select the New Coverage command from the pop-up menu. 6）. Change the Coverage name to Boundary. Change the Default . elevation to****. Change the Default layer range to go from 1 to****. 7）. Click OK. 6 Defining the Boundary定义边界 1 . Select the Create Arc tool . 2 . Create the arc by proceeding around the boundary. Dont worry about the spacing or the exact location of the points; just use enough points to define the approximate location of the boundary. 3 . To end the arc, double click on the point where you began. Note: As you are clicking on the points, if you make a mistake and wish to back up a point or two, press the Backspace key. If you wish to abort the arc and start over, press the ESC key. 7对弧分段定义不同类型的边界 1）. Select the Select Vertices tool select thefirst vertex and then hold down the Shift key while selecting the othervertex. 2）. Select the Feature Objects | Vertices - Nodes command. 3 ）. Building a Local Source/Sink Coverage 最好对不同的 汇源项分别建立各自的Coverage A Right click on the Boundary coverage and select the Duplicate command from the pop-up menu. Change the new coverage name to Sources/Sinks. B Right-click on the Sources/Sinks coverage and select the Coverage Setup command from the pop-up menu. 4 Defining the Specified Head Arcs（定义水头边界） 边界类型 Specified Head Specified flow general head A Select a arc use Select Arcs tool and holding down the Shift key while selecting the