api初始化串口.docVIP

api初始化串口.txt ///////////////////// 1。打开并配置串口 // 初始化串口 // 参数: port 串口号 // BaudRate 速率 BOOL CSerial::InitSerialPort() { CString csPortName; DWORD dwCfgSize;//串口配置数据结构的大小 csPortName = AfxGetApp()-GetProfileString(串口选择,端口号,NULL); if(csPortName.GetLength() 3) csPortName = COM1; //打开串口 m_hComPort = CreateFile(csPortName, GENERIC_READ | GENERIC_WRITE, 0, // 串口设备必须是独占使用 NULL, // no security attrs OPEN_EXISTING, //串口设备必须使用OPEN_EXISTING设置 0, // 输入输出不能重叠 NULL // hTemplate对于串口设备必须是NULL ); if (m_hComPort == INVALID_HANDLE_VALUE) { return FALSE; } //获得当前的串口默认配置 GetCommConfig(m_hComPort,m_CFG,dwCfgSize); //以下是固定的串口初始值 m_CFG.dcb.BaudRate = 4800; m_CFG.dcb.ByteSize = 8; m_CFG.dcb.fInX = 0; m_CFG.dcb.fOutX = 0; m_CFG.dcb.fOutxCtsFlow = 0; m_CFG.dcb.fRtsControl = 0; m_CFG.dcb.fParity = 0; m_CFG.dcb.Parity = 0; m_CFG.dcb.StopBits = 2; /*以下是预留的可更改串口初始值 m_CFG.dcb.BaudRate = AfxGetApp()-GetProfileInt(串口配置,BaudRate,0); m_CFG.dcb.ByteSize = AfxGetApp()-GetProfileInt(串口配置, ByteSize,0); m_CFG.dcb.fInX = AfxGetApp()-GetProfileInt(串口配置, fInX,0); m_CFG.dcb.fOutX = AfxGetApp()-GetProfileInt(串口配置, fOutX,0); m_CFG.dcb.fOutxCtsFlow = AfxGetApp()-GetProfileInt(串口配置, fOutxCtsFlow,0); m_CFG.dcb.fParity = AfxGetApp()-GetProfileInt(串口配置, fParity,0); m_CFG.dcb.fRtsControl = AfxGetApp()-GetProfileInt(串口配置, fRtsControl,0); m_CFG.dcb.Parity = AfxGetApp()-GetProfileInt(串口配置, Parity,0); m_CFG.dcb.StopBits = AfxGetApp()-GetProfileInt(串口配置, StopBits,0); */ //调用串口配置对话框 // CommConfigDialog(csPortName,NULL,m_CFG); // ; if(SetCommConfig(m_hComPort,m_CFG,sizeof(m_CFG))) { //保存当前串口的配置 AfxGetApp()-WriteProfileInt(串口配置, BaudRate,m_CFG.dcb.BaudRate); AfxGetApp()-WriteProfileInt(串口配置, ByteSize,m_CFG.dcb.ByteSize); AfxGetApp()-WriteProfileInt(串口配置, DCBlength,m_CFG.dcb.DCBlength); AfxGetApp()-WriteProfileInt(串口配置, EofChar,m_CFG.dcb.EofChar); AfxGetApp()-WriteProfileInt(串口配置, ErrorChar,m_CFG.dcb.ErrorChar); AfxGetApp()-Writ