包装设计系学生优秀纸盒设计作业选.docVIP

包装设计系学生优秀纸盒设计作业选 湖南工业大学包装设计系优秀纸盒设计作业选——包设053、054班 包设053班?黄华妍?糕点包装造型结构设计 包设053班?姜雯雯?首饰包装结构设计 包设054班?赵群?日用礼品包装套装造型结构设计 包设053班?张婧珍?耐克品牌宣传品包装造型 包设053班?赵晶?喜糖包装造型设计 包设054班?邓光琴?日用瓷包装结构 包设054班?黄研研?糕点包装造型结构设计 包设054班?王志?烟花礼品包装造型结构设计 包设054班?谢倩?传统土特产包装造型结构设计 包设054班?邹超?文房四宝礼品包装造型结构设计1 包设054班?邹超?文房四宝礼品包装造型结构设计2 包设054班?赵玲?糕点包装 spacing of 100mm. C, line line line nearby. D, spare wire unified terminal strip Terminal (terminal strip at the top of the vertical, horizontal terminal strip from the harness to Terminal Pai end at the beginning), length to ensure as far as Terminal and set aside. After e, form a wire harness, cable, line. When the line should be in the core wire for better identification and marking on the cards will be prepared in advance, alternate core core content for the cable numbering. F, finish line, according to the corresponding terminal locations, wire one by one from the bunch out, pulling line, should be kept parallel to each other and more. Core dark as possible, determined in accordance with specific conditions, it is required that: neat, beautiful, shapely, pleasing to the eye. 7.6.2 wiring technology, out of the core wire according to Terminal position, cut off the excess, with wire stripping pliers or electrician knife stripped of insulation, so that connection. Stripping should not damage the copper core. B, core wire on the oxide and chip-insulated electricians knife scrape. C, core processing has been completed, thread round long nose pliers in a clockwise direction. Circle with the screw in the direction of spin in the same direction, circle should be appropriate, it is best to slightly larger than the screws, bent round the circle and the length of root and appropriate so set screw is screwed on tight. D, when on the crimp-type terminals when wiring, threads do not have to bend. Insulating part should be careful not to press it into a Terminal, and make the loop doesnt make sense and to prevent bad head crimping, fell