结构力学考试大纲.docVIP

《结构力学（含动力学）》硕士研究生入学考试大纲 第一部分：考试说明 结构力学（含动力学）是武汉理工大学土木工程与建筑学院学术型硕士招生专业：岩土工程、结构工程、防灾减灾工程及防护工程、桥梁与隧道工程，全日制专业学位招生领域：建筑与土木工程硕士入学考试选考的专业基础课之一。 考试范围：结构力学（含动力学）。 考试形式和试卷结构： 答卷形式：闭卷，笔试，所列题目均为必答题。 答题时间：180分钟。 试卷结构和考试题型： 试卷共150分，为作图、分析计算题1、结构力学Ⅰ、Ⅱ基本教程，龙驭球、包世华、匡文起、袁驷主编，高等教育出版社。 2、《》，主编， spacing of 100mm. C, line line line nearby. D, spare wire unified terminal strip Terminal (terminal strip at the top of the vertical, horizontal terminal strip from the harness to Terminal Pai end at the beginning), length to ensure as far as Terminal and set aside. After e, form a wire harness, cable, line. When the line should be in the core wire for better identification and marking on the cards will be prepared in advance, alternate core core content for the cable numbering. F, finish line, according to the corresponding terminal locations, wire one by one from the bunch out, pulling line, should be kept parallel to each other and more. Core dark as possible, determined in accordance with specific conditions, it is required that: neat, beautiful, shapely, pleasing to the eye. 7.6.2 wiring technology, out of the core wire according to Terminal position, cut off the excess, with wire stripping pliers or electrician knife stripped of insulation, so that connection. Stripping should not damage the copper core. B, core wire on the oxide and chip-insulated electricians knife scrape. C, core processing has been completed, thread round long nose pliers in a clockwise direction. Circle with the screw in the direction of spin in the same direction, circle should be appropriate, it is best to slightly larger than the screws, bent round the circle and the length of root and appropriate so set screw is screwed on tight. D, when on the crimp-type terminals when wiring, threads do not have to bend. Insulating part should be careful not to press it into a Terminal, and make the loop doesnt make sense and to prevent bad head crimping, fell down, causing an open circuit. After wiring, may