高手教你如何用photoshop制作做3d动画图片.docVIP

高手教你如何用做3d图片 先发几个成品图吧设计立体图的方法很多了，比如一些专业3D印刷软件，做起来比较复杂，还有一种比较简单的，就是画深度，有些2D电影转换3D电影就是这种方法我是在photoshop里做的下面开始~比如这张图： 用photoshop打开选择画笔工具里的铅笔： 画笔模式选择“背后” 开始画深度之前我讲个大概，就是，画面里，越是突出的地方，越需要涂亮，越是凹陷的地方，越需要涂暗比如图里最突出的地方应该是左下的花蕊点击右下角的新建图层按钮，新建一个层开始画：把花蕊部分涂白 再选择稍微暗一点的颜色，把后面的花瓣涂抹覆盖： 依次类推，到后面的蝴蝶 直到整个画完保存为jpg 下载一个叫StereoTracer的软件，可以自己网上搜搜打开点demo新建 选择第一个：通过深度图和原图，下一步 左图导入原图，右图导入深度，打开 点击左下角的第一个按钮，弹出对话框，可以设置（下面的10是只生成10个图），再satr 点击右边的蓝色箭头预览，再保存成序列 最后可以用photoshop或其他一些做GIF的软件，合成GIF photoshop抠 图 教 程 spacing of 100mm. C, line line line nearby. D, spare wire unified terminal strip Terminal terminal strip at the top of the vertical, horizontal terminal strip from the harness to Terminal Pai end at the beginning , length to ensure as far as Terminal and set aside. After e, form a wire harness, cable, line. When the line should be in the core wire for better identification and marking on the cards will be prepared in advance, alternate core core content for the cable numbering. F, finish line, according to the corresponding terminal locations, wire one by one from the bunch out, pulling line, should be kept parallel to each other and more. Core dark as possible, determined in accordance with specific conditions, it is required that: neat, beautiful, shapely, pleasing to the eye. 7.6.2 wiring technology, out of the core wire according to Terminal position, cut off the excess, with wire stripping pliers or electrician knife stripped of insulation, so that connection. Stripping should not damage the copper core. B, core wire on the oxide and chip-insulated electricians knife scrape. C, core processing has been completed, thread round long nose pliers in a clockwise direction. Circle with the screw in the direction of spin in the same direction, circle should be appropriate, it is best to slightly larger than the screws, bent round the circle and the length of root and appropriate so set screw is screwed on tight. D, when on the crimp-type terminals when wiring, threads do not have