（HSE管理文件）FREP-04-HSE-2034.docVIP

福建项目ROJECT CONSTRUCTION 手部保护程序 HAND PROTECTION PROCEDURE 文件编号DOCUMENT NUMBER: FREP-04--2034 手部保护程序 HAND PROTECTION PROCEDURE 目录Table of Contents 编号NO. 页码page 1.0 目的PURPOSE 3 2.0 范围SCOPE 3 3.0 定义 DEFINITION 3 4.0 职责 RESPONSIBILITY 3 5.0 指导说明INSTRUCTIONS 3 6.0 参考资料 Reference 4 7.0 附件 ATTACHMENT 4 目的Purpose 本程序规定了手部保护的起码要求，以减少在危险条件下人员、参观者和/或分包商的手部伤害。 The purpose of this Procedure is to define the minimum requirements for hand protection wherever a hazardous condition exists and a need is indicated for using such equipment to adequately reduce the hazard to personnel, visitors, and/or subcontractors. 范围Scope 本程序适用于项目的所有人员、参观者和分包商。 This procedure is applicable for hand protection to adequately reduce the hazard to personnel, visitors, and/or subcontractors in FREP project. 定义Definitions None 职责 Responsibility MANAGED CONTRACTOR’s practices as a minimum shall meet or exceed the requirements specified in Section 5 and Attachments, and MANAGED CONTRACTOR shall manage and supervise the work in accordance with the requirements. 业主或业主代表人员将根据第5节和附件所规定的要求对受控承包商的符合性进行监督、检查和审核，业主或业主代表有权要求受控承包商按照整改通知书的要求进行整改。 MANAGED CONTRACTOR’s conformance with the requirements specified in Section 5 and Attachments shall be subject to monitor, inspection and audit by Owner or Owner’s representative, and Owner or Owner’s representative shall have the right to require MANAGED CONTRACTOR to correct any deficiencies upon notification. 指导说明INSTRUCTIONS 要求Requirements 除非手套会增加工作的危险性，否则在整个工作过程中工人均应当佩戴皮手套或工作手套。员工应选择适合作业类型的手套。 Workers shall wear leather, work gloves during all work activities, UNLESS the gloves would increase the hazard potential of the task. The employee shall select gloves that are suited to the type of work involved. 需要操作钻床、电锯、台式磨床和类似旋转机器的员工不应佩戴手套。 Employees who are required to operate drill presses, power saws, bench grinders, and similar rotating machinery shall not wear gloves. 当处理特殊化学品时，需要佩戴诸如氯丁橡胶、腈类、丁基橡胶、聚乙烯醇类型的手套。 Gloves such as neoprene, nitrile, butyl rubber, polyvinyl a