API 1104A.pptVIP

* API 1104 EIGHTEENTH EDITION “ Welding of Pipelines and Related Facilities ” This quiz is is designed to help a student study the API 1104, Eighteenth Edition, for use in the AWS Certified Welding Inspector examination. Read each question carefully and select the best answer by circling your choice. After selection of your answer, write in the section number your answer was found. Look up each question in the code book, remember this exercise is to help you learn to use the book. All 46 questions must be completed in two hours. 10.1 page 39 Automatic welding without filler-metal additions shall be done using the : A. GTAW process B. Oxy-fuel welding process C. Flash butt welding process D. None of the above Answer found in section Atmospheres for shielding an arc may consist of: A. Mixtures of inert and active gases B. Inert gases only C. Active gases only D. All of above Answer found in section 1.5.3.1 page 3 3. For welder qualification, the specimens shall be prepared for tensile-strength, nick-break and bend tests, when tensile-strength tests are omitted: A. The welder is not qualified. B. The weld must be redone. C. Extra face bends must be performed. D. Specimens designated for this shall be subject to the nick-break test. Answer found in section 4. The maximum allowable of alignment mismatch hi-lo for pipe of the same nominal wall thickness shall not exceed: A. 1 inch B. 1/16 inch C. 1/32 inch D. No maximum Answer found in section 3.5.2 page 19 4.2 page 20 5. The exposed surfaces of each nick-break shall be show: A. Slag inclusion over 1/8 inch. B. At least 3/4 inch sound weld metal. C. Complete penetration and fusion. D. The tensile strength of the specimen. Answer found in section Lineup clamps shall be used for butt welds in accordance with the procedure specification. When it is permissible to remove the lineup clamp before the root bead is complete: A. The completed part of the bead shall be in equal segments space