HP磨煤机动态分器技术介绍.docVIP

动态分离器技术介绍 Introduction of Dynamic Classifier Technology 随着电力事业的快速发展，世界各国对电厂环保的要求越来越高，许多机组都在使用低NOx排放技术。为了降低NOx和飞灰排放量又不增加运行成本，作为锅炉系统重要辅机的磨煤机也相应进行了技术改进，采用了动态分离器技术。 With the rapid development of electric power project,most countries begin to think much of the environment. As a result, many units are incorporating infurnace low NOx technology. For reduceing the NOx and ash and without disposal cost, pulverizer that is one of the most important assistant equipment of the boiler system have been improved and equipped with Dynamic Classfier . HP磨煤机配套的动态分离器装置主要包括以下几个部分： The primary components of the Dynamic Classifier are: 轴承和驱动装置 Bearing and Drive Assembly 变频电机和涡轮蜗杆减速器 Variable Frequency Motor and Worm Gear Reducer V带 V-Belt 变频器 Pulse Width Modulated Variable Frequency Drive VFD 转子装置 Rotor Assembly 动态分离器使用一对脂润滑角接触球轴承，轴承放置在结构件制成的轴承座中，上、下轴承各有一个热电阻用于监测轴承温度。为了保护轴承，上、下各有一个油封。迷宫气封的设计也是为了防止粉尘进入驱动装置。 The Dynamic Classifier use two grease lubricated angular contact ball bearings installed in fabricated steel housing.There are two thermocouples to monitor the temperature of the two ball bearings.To protect the bearings,upper and lower oil seals are used.Labyrinth design air selas are also used to seal the drive assembly from coal dust. 变频电机和涡轮蜗杆减速器通过联轴器连在一起，变频电机通过变频器改变频率从而改变转速。涡轮蜗杆减速器输出轴上安装主动轮，通过皮带带动与转子装置连接在一起的从动轮，从而使转子转动。转子的旋转方向为从磨煤机上方往下看为顺时针方向。 The Variable Frequency Motor and Worm Gear Reducer are connected by a coupling.The frequency of the motor is changed by the VFD and then the speed of the rotor can be changed.A driver sheave is assembled at the output shaft of the worm gear reducer,and it drives the drived sheave which is connected with the rotor assembly ,and so the rotor can rotate.The Dynamic Classifier Rotor is designed to rotate in a clock-wise direction when viewed from above the mill. 变频器采用成熟技术制成，与机械变速相比，变频器几乎不用维护，可靠性很高。 VFD have high reliability using proven technology with little or no required maintenance as compared to mechanical speed control. 转子采用耐磨合金