04016模具控加工技术.docVIP

课程名称：模具数控加工技术 课程代码：04016（理论） 第一部分 课程性质与目标 课程性质与特点 本课程是模具设计与制造专业的一门重要专业课。其主要目的和任务是使考生掌握模具数控的各种先进加工方法，能够使用各种数控系统并在相应的数控机床上进行操作完成零件的加工本门课程实践性、综合性较强，在各部分内容中均应重视与生产实践相结合，注意有关知识的综合应用。塑料成型工艺与模具设计贾慈力模具数控加工技术及应用D、G56 2．执行G00 X30 Z6； G91 G01 X0 Z15；两个程序段后, Z正方向实际移动量（ ） A、9mm B、21mm C、15mm D、30mm （四）简答题 什么叫极性效应？在电火花加工时选择极性效应的原则是什么？ （五）编程题 1．加工如下图所示的凸台模具，其中加工轨迹为OA→AB→BC→CD→DE→EF→FG→GA，要求用刀具半径补偿指令编程，刀具直径采用Φ6mm。 manufacturers drawings bolt fastened in the cylinder and outer cylinder. Cylinder cylinder in the drain pipe installation and measuring component leads. 6.4.4.3 blade carrier, partitions and lower installation check the sealing ring of the seal and springs, which shall conform to the technical requirements manufacturers drawings. Cylinder gasket on the mounting brackets supporting the Group assembled, the lugs shall be no Burr on the surface, and other debris. Department suite in place to measure surface and inner cylinder surface height difference, compared with the original values confirm the location. 6.4.4.4 lower bearing and thrust bearing installation clean bearing and bearing, thrust bearing joints, clean them with a thin layer of turbine oil, and then lifting it to bits. 6.4.4.5 high and middle pressure cylinder over it to the end (for high pressure rotor and low pressure change flange gasket without connection unit) rotors and rotor flange gasket connection and there is no connection, so the rotor in place cases, rotors in place must be high and middle pressure cylinder together with the Chamber over it to the end. Jack in the box that are installed on a push-pull device of adjusting the high and medium pressure cylinder to end over and around to set up indicators to monitor data, general data about the difference must not exceed 0.02mm. To prevent cylinder about out of sync over the situation, take the following measures: a) over Jack uses the same pump, evenly. B) left to set up indicators to monitor over quantity