3Ds MAX例教程：制作IE的图标LOGO.docVIP

3Ds MAX实例教程:制作IE的图标LOGO 关键词:3Ds MAX实例教程:制作IE的图标LOGO这是一个非常简单的LOGO制作，如果是3D高手的话就不用看了，这只是一个适合初学者看的教材。 　　1、先在FLASH中做好要做LOGO的图形，然后生成AI文件。 　　2、在3DMAX中到入生成的AI文件。 　　3、旋转90度，使它与正视图平行。 4、鼠标右键，使图形变成可编辑曲线。 　　5、打开修改面板，进入顶点修改中，然后配合Ctrl键把没有闭合的点焊接好。(观察是否焊接好的方法，移动田字型的顶点，如果断开就证明没有焊接好。) 　　6、进入修改下拉菜单，选择倒角工具。 　　7、调节倒角值，如果图形有错误，可能是因为曲线有顶点没有焊接好。 8、新做一个圆形曲线。 　　9、步数值改为20，用移动和缩放工具调整位置，然后右键，使图形变成可编辑曲线。 　　10、用修改曲线工具中的偏移工具，做出两个曲线。同时把中间的曲线分离出来，使中间的线变为单独的曲线。这个曲线将做路径用。 　　11、把非独立的两条曲线用刚才做倒角的放法做出可以看见的面的形状，倒角值不需要设置。 12、做一个球型物体。 　　13、按图的步骤做。 　　14、先点添加路径，然后在点一先被分离出来的那条曲线。OK路径动画完成了。 manufacturers drawings bolt fastened in the cylinder and outer cylinder. Cylinder cylinder in the drain pipe installation and measuring component leads. 6.4.4.3 blade carrier, partitions and lower installation check the sealing ring of the seal and springs, which shall conform to the technical requirements manufacturers drawings. Cylinder gasket on the mounting brackets supporting the Group assembled, the lugs shall be no Burr on the surface, and other debris. Department suite in place to measure surface and inner cylinder surface height difference, compared with the original values confirm the location. 6.4.4.4 lower bearing and thrust bearing installation clean bearing and bearing, thrust bearing joints, clean them with a thin layer of turbine oil, and then lifting it to bits. 6.4.4.5 high and middle pressure cylinder over it to the end (for high pressure rotor and low pressure change flange gasket without connection unit) rotors and rotor flange gasket connection and there is no connection, so the rotor in place cases, rotors in place must be high and middle pressure cylinder together with the Chamber over it to the end. Jack in the box that are installed on a push-pull device of adjusting the high and medium pressure cylinder to end over and around to set up indicators to monitor data, general data about the difference must not exceed 0.02mm. To prevent cylinder about out of sync over t