华侨大学毕业设计（论文）.doc

华侨大学毕业设计（论文） 题 目某化工设备公司供配电 设计 院 系 信息科学与工程学院 专 业 电气工程及其自动化 班 级 2班 学生姓名 张志旭 学 号 0815312035 指导教师 方瑞明 教授 2012年5 月25号  摘 要 工厂供电就是指工厂所需电能的供应和分配，亦称工厂配电。 具体过程和步骤:根据工厂总平面图,工厂负荷情况,供电电源情况,气象资料,地区水文资料和电费制度等,先计算电力负荷,判断是否要进行无功功率补偿,接着进行变电所位置和式选择,并确定变电所变压器台数和容量, 主接线方案选择,进行短路电流的计算,并对变电所一次设备选择和校验和高低压线路的选择Plant power supply, means power plants needed to supply and distribution. Power supply in factory is meaning to electricity energy which is obtained from the power system is transferred reasonable, and it is distributed to the electric device of the factory floor. With the development of the society, the quality, reliability and economy demands of the electricity energy were increasing to the factory. Whether the design of the factory electricity supply is perfect not only affects the plants production, but also reflects the reliability of power supply to the factory and safety, it is closely related to the economic benefit of enterprises, equipment, safe operation and safety of workers, it is important for the development of production for doing a good job of the factory power supply work. Detailed process and the steps: according to the factory total plan, the load condition ,the power supply, the meteorological data, the district hydrologic data and electric system, the first calculated to power load, judge whether calculated to reactive power compensation, and choose the position and type of the substation , and determine the transformer substation numbers and capacity, the main connection scheme selection, they concluded the calculation of short-circuit current, and once for substation equipment selection and calibration, and high and low voltage circuit choice. Then design relay protection and lightning protection for substation. Finally draw the electrical main wiring diagrams and fl