充分发挥基层党织和党员的先锋模范作用.docVIP

全市纪念建党90周年 理论研讨会交流论文 在灾难中历练 在重建中奋进 ——以5·12地震灾后重建谈基层党组织和党员的重要作用 中共康县委书记　王钧 “5·12”大地震是一场百年不遇的历史性灾难，这场灾难给全县经济社会发展和群众生产生活造成了惨重损失，但灾后重建也带来了前所未有的发展机遇，更对基层党组织和广大党员提出了严峻的挑战和考验。三年灾后重建，使康县经济社会发展水平和群众生产生活条件明显超过灾前水平，农村发展呈现出崭新面貌，学校、医院等公共服务设施水平大幅提升，公路交通、城镇建设、防灾减灾等基础设施保障能力明显提高，精神家园得到了同步重建，群众不仅住上了好房子，而且逐步向过上好日子迈进，重建后的康县正在焕发出勃勃生机。这得益于党中央、国务院和省委、省政府的亲切关怀，得益于市委、市政府的坚强领导，得益于方方面面的援建和社会各界的大力支持帮助，更得益于全县各级组织和广大党员 Ellipticity of elbow pipes with diameters less than or equal to 150 mm must be not greater than 8% diameter of 200 mm or less shall not be greater than 6%. Wall thickness of the pipe wall thinning rate must not exceed the original 15%. Crease roughness: diameter 125 mm or less, shall not exceed 3 mm diameter less than or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports and hangers of checks and the number 1) hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings and documents; 2) supports and hangers of material, size and accuracy shall conform to the provisions of the design drawings, material technical requirements should be consistent with national standards, industry standards and technical requirements related to the alloy spectrum review should be carried out; 3) pipe suppor