多措并举 惩防合 努力开创全镇党风廉政建设和反腐败工作新局面.docVIP

多措并举　惩防结合 努力开创全镇党风廉政建设和反腐败工作新局面贯彻《党员领导干部廉洁从政若干准则》，落实关于领导干部报告个人有关事项的制度，开展拒腐防变教育，大力弘扬廉政文化，提高党员领导干部的廉洁从政意识和自觉接受监督的意识。开展主题教育活动37次，送廉政提醒短信组织专题培训班25个，培训党员干部1000余人次。党员领导干部廉洁从政若干准则建立健全“以项目论英雄、以项目评干部”的正确导向，强化干部执行力，叮住不落实的人、抓住不落实的事，严肃查处妨害经济发展环境、损害投资者利益的行为，努力做到“办事效率最高，发展成本最低，干部队伍最廉，发展环境最优”。针对目前中小学校乱收费、乱办班、乱补课、滥订教辅资料等群众反映强烈的突出问题，纪委将采取明察暗访的形式，加强监督检查，同时要认真落实农村义务教育阶段“两免一补”政策，确保落实到位。 Ellipticity of elbow pipes with diameters less than or equal to 150 mm must be not greater than 8% diameter of 200 mm or less shall not be greater than 6%. Wall thickness of the pipe wall thinning rate must not exceed the original 15%. Crease roughness: diameter 125 mm or less, shall not exceed 3 mm diameter less than or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports and hangers of checks and the number 1) hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings and documents; 2) supports and hangers of material, size and accuracy shall conform to the provisions of the design drawings, material technical requirements should be consistent with national standards, industry standards and technical requirements related to the alloy spectrum review should be carried out; 3) pipe supports and hangers part plant pro