困气位置，所需锁模力和注塑压力-ebestmould.pptVIP

* Actual of cavities 实际出模数: 10 parts Number of cavity analysis 分析时出模数: 10 parts Part Material 塑胶材料: PA6+50%GF Type of analyses 分析类型: Flow + Warp Project Summary Analysis Purpose Validate potential problem after the part design 验证可能存在的问题在产品设计完成后 Check the fill balance pattern, weld line, air traps, and predict the needed clamp force and injection pressure, warpage. 指出流动模式，熔接线位置，困气位置，所需锁模力和注塑压力，产品变形 Estimate cycle time 评估周期 Input Model Description The runner system is simulated as the mold design. 根据模具设计建立流道为分析 Result Required Filling result 流动结果 Cycle time result 周期结果 Warpage res