component3-glowblogs.docVIP

To measure direct current: connect the black lead to the ‘COM’ socket connect the red lead to the ‘mA’ socket make sure ‘d.c.’ is selected move the dial into the current (amps) range select a suitable range (always slightly higher than the expected measurement) connect the probes to the wire in which the current is to be measured. To measure resistance: connect the black lead to the ‘COM’ socket connect the red lead to the ‘V(’ socket make sure ‘d.c.’ is selected move the dial into the resistance (ohms) range select the range (always slightly higher than the expected measurement) connect the