关于罩退一期排风机电机电流过高的一些分析.docVIP

关于罩退一期排烟风机电机电流过高的原因分析 目前，罩退一期排烟风机在正常运行时电机的电流偏高，在风机风门调节到最佳位置的情况下，1#电机的电流可达到147A左右，2#电机的电流达到136A左右，（电机功率：75KW，额定电流：141A）。经分析，其中一个原因是1#～24#炉台的烟道管自力式翻板阀现在都不能自动关闭，使烟道管里面被吸进了大量的冷风，使烟道管里的温度达不到最佳的风机运行温度，从而使电机的负荷增大，电流增加。自力式翻板阀如下图： 图1 图2 图3 说明： 图1和图2是一期1#至24#炉台的自力式翻板阀，目前已不能自动关闭（当加热罩吊离后）。图3是二、三期的自力式翻板阀，带有手动关闭手柄，即当加热罩吊离后如果不能翻板阀不能自动关闭的话可人工手动关闭。目前已发现二、三期的自力式翻板阀大部分也是不能自动关闭的，当加热罩吊离后。原因是翻板阀上面也是逐步逐步结了不少和一期一样的污垢，但却没有相关人员处理，而且当加热罩吊离后也无人（现场操作人员）去手动关闭（其实当加热罩吊离后操作人员只需两到三秒钟的时间就能将其关闭，但没有一个现场操作人员这样做）。如果长期这样的话，二、三期的这些翻板阀也会像现在一期的一样最后都无法关闭，结果就会使排烟风机的电机电流升高，能耗增加。 附带不合理现象： 图4 图5 操作人员操作完后没把按钮护盖盖好！ center pin checks and anchoring the inner cylinder. According to While coupling alignment should keep oil out of cavity and locate the rotor axis neck raised are within the prescribed limits, there should be no gaps, Horn, Horn and Horn 0.05mm feeler gauges fit into. Center coupling, condenser water filling and water-filled according to factory requirement. For coupling three supported rotor Center, the mouth under the coupling between the value should be as stipulated in the manufacturer, usually 0.15~0.25mm. In the case of coupling connection, if possible, lifting only one bearing end of the support bearing of the rotor, remove the bearing, fitted with special tiles and special lifting tools, disc rotors, check the journal flutter tile, should generally be less than 0.10MM. When the couplings and rotor comes when there is a conflict, the coupling Centre shall prevail. 6.4.5.2.2 shaft looking for: ... 6.4.5.3. Provisional bolt confirmed the positioning of the rotor size, as well as the coupling between the adjustment shim thickness accuracy, drawings to meet the technical requirements. Plane, cylindrical and clean the coupling bolt holes should be clean and without burrs, scrap iron and grease-free, relative position of the coupling according to the drawing requirements are. Coupling top screws, round distance apart, indicators to monitor movement of the aircraft, its