东营石油综合行政办公楼建筑结构设计--本科毕业设计.docVIP

毕业设计 东营石油大学综合行政办公楼建筑结构设计 摘 要 本毕业设计题目为“东营石油大学综合行政办公楼建筑结构设计”。设计的内容包括建筑设计、结构设计两部分。建筑设计是在总体规划的前提下，根据设计任务书的要求，查阅办公楼设计规范，确定设计方案，画出建筑施工图。结构设计是在建筑物初步设计的基础上确定结构方案并绘制结构施工图。 本设计采用钢筋混凝土现浇框 架结构，建筑面积为8748.54㎡ DESIGN OF BUILDING STUCTURE OF THE ADMINISTRATIVE OFFICE OF DONGYING PETROLEUM UNIVERSITY ABSTRACT The topic of graduation project has been shown as the title, and this project includes design of architectural design and structural design. According to the assignment book, the architectural design is to plot the construction drawing of the objective building under the specification for the office design. And based on the architectural design, the structural design is to plot the structural construction drawing with the corresponding structural calculation. The objective of this project is framework construction of cast-in-place reinforced concrete. This building insist of overground with six floors (3.6m per floor) and underground parking lot (4.2m), and the total height of this building comes to 21.6m. According to the design requirement, fortification intensity comes to 7 and class of anti-seismic measure is 3, also this project didn’t consider the wind load. The main structure in this project is bearing frame in both virtual and horizontal direction. After the calculation of loading and section, the author used single frame for calculation, and the content of calculation include the selection of section measurement of girder and column and the calculation of linear stiffness; the calculation of moment, shearing force and axial force at the end of girder and column; regulation of internal force of girder; arrangement of internal force if girder and column; calculation of reinforcement of girder, column, stairs, floor and the raft foundation. . During the all the procedure of design, the corresponding specification and materials have been referenced. And each of the segment have been considered sufficiently. In a word, the project take th