信阳联达实业有责任公司2015年春检督查整改报告.docVIP

签发人： 信阳联达实业有限责任公司 关于落实省公司春检督查整改情况 大唐河南发电有限公司经营策划部： 根据《大唐河南发电有限公司2015年多种经营春季安全大检查督查情况通报》（大唐营综〔2015〕13号），公司领导高度重视，多经监管委员会和公司各级领导分别做出要求，并安排部署整改工作。 信电公司多经监管委员会主任白献锁、吴利民，副主任李涛分别作了重要要求。吴书记要求联达公司按照集团公司对多经的定位做好“两服务、两安置”工作，确保三大安全。白总提出2015年要重点抓好四项工作：一是夯实安全生产基础，确保安全生产稳定。从小事抓起，大事入手，认真开展隐患排查治理，深化设备治理，防止人身伤亡事故，提高安全管理水平。二是依法依规，树立红线意识、底线意识，做好联达公司的经营工作。三是做好后勤服务工作，尽力满足职工的要求，提高职工满意度。四是提高对外协调能力，做好水管线、35KV线路沿线协调工作。信电公司副总经理、多经监管委员会副主任李涛要求：要对照通报情况，逐项落实好整改工作。春检督查整改吸取其他兄弟单位的亮点和存在的问题，结合实际工作，进行学习和自查。 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks or finishing. bearing surface,