Altium中图设置走线.doc

1??在原理图中，让一对网络名称的前缀名相同，后缀分别为_N 和_P，左键点击Place\ Directives\Differential Pair,这时，鼠标上就出现差分队对指示标志，给差分对的两根线都加上差分队对指示。 将差分信息加载到PCB 文件中来，并定义用户需要的差分规则保存编译文件，并且编译顶层的原理图。左键点击Design\Updae PCB document…,启动Engineer Change Order, 把有关的差分对信息加入到PCB 文件中来，保存PCB 文件。在PCB文件中，转移到PCB面板，在靠近PCB这三个字母旁边的行中选择Differential Pairs Editor ,在下面的框中选中All Differential Pairs ,这样，所有定义的差分对就在Designer 框中出现了。选中定义的差分对（如RT），左键点击 Rule Wizard按键，进入Differential Pair Rule Wizard界面，点击 Next 按键 ,回进入各个参数输入界面，可以选择输入各种参数。 3 使用差分走线命令完成差分对走线左键点击Place\Differential Pair Routing ,进入差分对布线模式，此时，用鼠标在差分网络的两个相邻的焊盘上点击一下， 然后移动鼠标， 就会看到对应的另一跟线也会伴随着一起平行的走线，同时按下Ctrl +Shift 并且转动鼠标的滚轮， 就可以两跟线同时换层。 如果觉得差分线不够等长的话 在这个Tools是里头还有交互差分等长的调整的，自己试试吧！ ? 再说说我遇到的一个新问题，就是前面在AD Summer 08下面做的工程文件，用AD winter 09 打开时候居然文件的层次管理无效了，让我好好郁闷了几天的，仔细的摸索一下，原来如此： 原来在这个地方要打勾的 ，我的勾勾呢 ，居然不知道何时不见了，呵呵！ office, branch offices (jurisdiction), risk management, marketing management sector through supervision and inspection found problems, should be assigned the investigators are corrected in a timely manner. 27th the fifth chapter penalty under any of the following acts, then the relevant provisions to punish the investigators, according to the Bank. To constitute a crime shall be investigated for criminal responsibility: (A) on the business that are not involved in the investigation, issued a survey. (B) customer credit information are not thorough verification. (Iii) to participate in credit customer survey is not in place, customers and data is incomplete, untrue; he knows bear a counterfeited clients issuing credit. (D) does not provide for due diligence of credit business, pre-loan investigation form, concealing facts or providing false information or should be found in a normal investigation failed to discover the risk factors, lead to the review and approval policy errors, loan risk. (Five) on loan guarantees of survey not in place, not by provides on arrived, and pledge real for field verification, and assessment, and identification and registration, not