十二种方法推导到直线的距离公式.docVIP

{十二种点到直线距离公式证明方法} 用高中数学知识推导 点到直线的距离公式 的方法． 已知点P(Xo，Yo)直线l：Ax+By+C=0 (A、B均不为0)，求点P到直线I的距离。(因为特殊直线很容易求距离，这里只讨论一般直线) 《1．用定义法推导》 点P到直线l的距离是点P到直线l 的垂线段的长，设点P到直线l的垂线为垂足为Q，由l垂直l’可知l’的斜率为B/A 《2，用设而不求法推导》 《3，用目标函数法推导》 《4，用柯西不等式推导》 “求证：(a2 +b2 )(c2+d2)≥(ac+bd)2,当且仅当ad=bc，即a/c=b/d时等号成立。”实为柯西不等式的最简形式，用它可以非常方便地推出点到直线的距离公式。 《5．用解直角三角形法推导》 设直线l的倾斜角为，过点P作PM∥y轴交l于G(x1 ，y1)，显然Xl=x。，所以 《6，用三角形面积公式推导》 《7．用向量法推导》 《8．用向量射影公式推导》 《 9．利用两条平行直线间的距离处处相等推导》 《10．从最简单最特殊的引理出发推导》 {11．通过平移坐标系推导】 【12，由直线与圆的位置关系推导】 感谢以下挚友，俺其实只是负责编辑整理了一下，证明下，感受下数学滴博大精深 and performance test copies of the record. If necessary, review should be carried out; 4) for spring hangers (included simple spring, hangers and constant support hangers) it should also be recognized as setting and locking of loads. 5) check the surface quality, folded layering and without cracks, rust and other defects. 5) after completion of the test and control drawing number one by one, by series baled. Color alloy steel parts, the parts marking installation location and rotation about the direction you want. 7.3.14. hangers installation 7.3.14.1 hanger layout a. a clear design of hanger should be installed strictly in accordance with the drawings and designs shall not be installed wrong, missing, etc. B. own arrangement of piping support and hanger set and selection should be based on comprehensive analysis of general layout of piping systems; cold installation of steam pipe with particular attention reserved for compensation of thermal expansion displacement and orientation. C. support systems should be rational to withstand pipe loads, static load and incidental load; reasonable piping displacement; guaranteed under various conditions, stress are within the allowed range. Strength, stiffness, and meet requirements to prevent vibr