西交大考研机械计基础第十五章 螺纹连接.docVIP

第十五章 螺纹连接 15-12、已知气缸的工作压力在之间变化。汽缸内径，汽缸盖螺栓数目为16，结合面间采用铜皮石棉垫片。试计算汽缸盖螺栓直径。 15-13、一托架用6个铰制孔用螺栓与钢柱相连接，作用在托架上的外载荷。就图15-48所示的三种螺栓组布置形式，分析哪一种布置形式螺栓受力最小。 15-14、图15-49是由两块板焊成的龙门式起重机导轨托架。两块边板各用4个螺栓与立柱（工字钢）相连接，支架所承受的最大载荷为20000N,使设计： （1）、采用普通螺栓连接（靠摩擦传力）的螺栓直径d; （2）、采用铰制孔用螺栓连接（靠剪切传力）的螺栓直径d，设已知螺栓的。 and performance test copies of the record. If necessary, review should be carried out; 4 for spring hangers included simple spring, hangers and constant support hangers it should also be recognized as setting and locking of loads. 5 check the surface quality, folded layering and without cracks, rust and other defects. 5 after completion of the test and control drawing number one by one, by series baled. Color alloy steel parts, the parts marking installation location and rotation about the direction you want. 7.3.14. hangers installation 7.3.14.1 hanger layout a. a clear design of hanger should be installed strictly in accordance with the drawings and designs shall not be installed wrong, missing, etc. B. own arrangement of piping support and hanger set and selection should be based on comprehensive analysis of general layout of piping systems; cold installation of steam pipe with particular attention reserved for compensation of thermal expansion displacement and orientation. C. support systems should be rational to withstand pipe loads, static load and incidental load; reasonable piping displacement; guaranteed under various conditions, stress are within the allowed range. Strength, stiffness, and meet requirements to prevent vibration and soothing water, without affecting the adjacent equipment maintenance and other piping installation and expansion. D. equipment connected to the interface to meet pipeline thrust torque limit requirements; increase the stability of piping systems to prevent pipeline ... Tube wall thickness mm 2-3 4-6 7-10 weld form no slope mouth weld strengthening height h mm 1-1.5 1.5-2 weld width b mm 5-6 7-6 has slope mouth weld strengthening height