神经系统复习内 - 副本.docVIP

第十五章 前庭蜗器 1． 2． 3． 4． 5． 6．． 8．熟悉声波的传导途径。 ? ? ? 第十六章 神经系统 ? 第一章 ?总论 ?? 1．掌握神经系统的区分。了解神经元的形态结构及分类。 ?? 2．掌握反射弧的组成。 ?? 3．掌握神经系统的常用术语（灰质、神经核、髓质、神经节）。 第十七章? 中枢神经系统 第一节 脊 髓 1． 2． 3． 4． 5． 第二节? 脑? 一、脑干 1． 2． 3． 4． 5． 二、小脑 1．掌握小脑的位置、外形、分叶和机能分区。 2．了解小脑核的名称、位置。 3．了解小脑的纤维联系与功能。 三、间脑 1． 2． 3． 4． 四、端脑 1． 2．I躯体运动区、第I躯体感觉区、视区、听区的位置及功能定位。掌握四个语言中枢的位置及损伤后的表现。 3． 4． 5． 6． coupling Centre shall be checked, the second poured concrete strength of more than 70%. In the process of reaming or boring, apart from the special provisions in factory, does not allow any work that may affect the coupling Centre, such as irrigation, to cylinder connections to flood the condenser pipes and so on. Well boring, hinge bolt hole flange with coupling of vertical, not oblique. Mounting bolts should be added lubricants, typing gently with a small hammer, not too loose or too tight, packed the bolts with the corresponding seal screw hole should be marked. 6.4.5.4.2 coupling reamed and pairings is close to the diameter of bolt bearing good hinge holes, dressed with a good two coupling bolts before you can move the rotor, boring-reaming hole in turn. Coupling bolts must be tight coupling is symmetrical diameter, in boring, reaming, two bolts out. Well boring, hinge bolt hole flange with coupling of vertical, not oblique. Due to the coupling bolts in accordance with hinge holes corresponding to the diameter of the screw holes one by one after processing, processing back bolt installation location cannot be changed, so according to bolt after the actual weight difference of nut and lock washer to match. General requirements for coupling two symmetrical diameter bolt, nut and lock washers total weight difference should not be greater than 10 g and knocks stamped mark. (See Figure 18) The coupling bolts apply lubricant, and then gently with copper home, not too loose or too tight. Bolt Assembly is finished, symmetrical tightening all bolts to 30%, 50%, 70%, 100% force, and check the coupling flutter and b