华南理工大学21年电信学院研究生专业介绍.docVIP

华南理工大2011年 081001通信与信息系统 69 通信理论与技术 ? ? 陈芳炯??丁泉龙??董守斌??杜明辉??冯穗力??贺前华??胡斌杰??季飞??姜胜明??金连文??李融林??林耀荣??陆以勤??史景伦??王伟凝??韦岗??谢胜利??谢泽明??薛锋章??余华??张军??张凌??张平??张远见??褚庆昕 ? 101政治 201英语一301数学一824信号与系统 复试笔试科目：923模拟电子技术基础和数字电子技术基础 02通信网络理论与技术 同上 03通信信号处理 同上 04数字音视频处理 同上 05多模态人机通信 同上 081002信号与信息处理 51 824信号与系统考试大纲 824 ?信号与系统 ?《信号与系统》[美]ALAN.OPPENHEIM,ALANS.WILLSKY,刘树棠译,西安交通大学出版社1998.3(第二版);《Signals?and?Systems》(Second?Edition)[美]?Alan?V.Oppengeim,Alan?S.Willsky,S.Hamid?Nawab,电子工业出版社 ? 点击查看 923 ?模拟电子技术基础和数字电子技术基础 ?《模拟电子技术基础》(第四版)清华大学电子学教研组编；华成英、童诗白主编；高等教育出版社2006;《数字电子技术基础》(第五版)阎石主编,高等教育出版社2006 ? 点击查看 923模拟电子技术基础和数字电子技术基础考试大纲 appearance of the weld appearance quality technical requirements of the project must not have a molten metal stream does not melt the base metal to weld, weld seam and heat-affected zone surface must not have cracks, pores, defects such as crater and ash, surface smoothing, weld and base metal should be evenly smooth transition. Width 2-3 mm from the edge of weld Groove. Surface reinforcement should be less than or equal to 1 + 0.2 times the slope edge width, and should not be greater than 4 mm. Depth of undercut should be less than or equal to 0.5 mm, total length of the welds on both sides undercut not exceed 10% of the weld length, and long continuous should not be greater than 100 mm. Wrong side should be less than or at 0.2T, and should not be greater than 2 mm (wall thickness mm t) incomplete or not allow 7.5 7.5.1 installation quality process standards of the electrical enclosure Cabinet surface is clean, neat, no significant phenomenon of convex, close to nature, close the door. 7.5.2 Cabinet Cabinet face paints no paint, returned to rusted, consistent color. 7.5.3 uniform indirect gap from top to bottom, slot width 1.5mm 7.5.4 adjacent Cabinet surface roughness is 0. 7.5.5 the cabinets firmly fixed, crafts beautiful. 7.5.6 Cabinet surface gauge, switch cabin