给排水管道预留缝隙防渗漏施工方法.doc

给排水管道预留洞缝隙防渗漏施工方法“穿JS材料）做得再好，都存在渗漏”经过多次摸索，我们发现了一种新的“管道”施工方法，他便、快捷、??下面我就向大家分享一下我的施工 首先“管道”：  1、管洞孔直外60mm， 2、  施工缺点： 1、必2-3人 2、安装一套至少需5分1小??传统封堵方式人工制作粗糙，施工面凸凹不平，混凝土出台，（突出楼板平面）漏浆，污染管道墙壁，需人工后期清理凿磨，稍有不慎即伤及管道。 3、上下返工更 4、人工制模（采用三合板或者 5、制作麻 6、制作、安装、后期,需施工方反  管道 下面我“管道” 【  施工步 步 步 步 步  施工特点： 一、施工速度快，安装6~8倍，90%以上。 二、可多次重 三、施工面平整光接合在施工技和施工 四、施工后， 五、上下 六、各  总结：通“管道”应运而生，解决了管道系统预留洞吊模施工多年的渗漏问题，大大提高了建筑施工中施工速度，以及施工质量。填补了我国建筑系“管道”施工空白中的空白。我“管道”必！ coupling Centre shall be checked, the second poured concrete strength of more than 70%. In the process of reaming or boring, apart from the special provisions in factory, does not allow any work that may affect the coupling Centre, such as irrigation, to cylinder connections to flood the condenser pipes and so on. Well boring, hinge bolt hole flange with coupling of vertical, not oblique. Mounting bolts should be added lubricants, typing gently with a small hammer, not too loose or too tight, packed the bolts with the corresponding seal screw hole should be marked. 6.4.5.4.2 coupling reamed and pairings is close to the diameter of bolt bearing good hinge holes, dressed with a good two coupling bolts before you can move the rotor, boring-reaming hole in turn. Coupling bolts must be tight coupling is symmetrical diameter, in boring, reaming, two bolts out. Well boring, hinge bolt hole flange with coupling of vertical, not oblique. Due to the coupling bolts in accordance with hinge holes corresponding to the diameter of the screw holes one by one after processing, processing back bolt installation location cannot be changed, so according to bolt after the actual weight difference of nut and lock washer to match. General requirements for coupling two symmetrical diameter bolt, nut and lock washers total weight difference should not be greater than 10 g and knocks stamped mark. (See Figure 18) The coupling bolts apply lubricant, and then gently with copper home, not too loose or too tight. Bolt Assembly is finis