西安科技大学毕实习报告模板.docVIP

机械工程学院毕业实习报告 学 生 姓 名 学 生 学 号 专 业 班 级 指 导 教 师 实 习 地 点 实 习 日 期 毕业实习报告撰写要求1 实习报告需写明实习目的、实习时间、实习地点2 实习报告需对实习单位作简要介绍，如单位性质、创办时间、组织结构、发展目标、地理位置、主要产品及市场营销状况3 实习报告需着重介绍实习生本人在实习中参观了哪些工种（工艺），或从事了哪些工作，如何开展这些工作，从中学到了哪些知识和技能，选材、加工工艺、加工设备数据4 实习报告需叙述实习生在实习中的收获和深刻体会5 实习报告需要结合实习单位的实际情况和所学的有关方面的理论知识，分析的优势与特点，及其存在的问题，提出解决方法尊敬实习单位 appearance of the weld appearance quality technical requirements of the project must not have a molten metal stream does not melt the base metal to weld, weld seam and heat-affected zone surface must not have cracks, pores, defects such as crater and ash, surface smoothing, weld and base metal should be evenly smooth transition. Width 2-3 mm from the edge of weld Groove. Surface reinforcement should be less than or equal to 1 + 0.2 times the slope edge width, and should not be greater than 4 mm. Depth of undercut should be less than or equal to 0.5 mm, total length of the welds on both sides undercut not exceed 10% of the weld length, and long continuous should not be greater than 100 mm. Wrong side should be less than or at 0.2T, and should not be greater than 2 mm (wall thickness mm t) incomplete or not allow 7.5 7.5.1 installation quality process standards of the electrical enclosure Cabinet surface is clean, neat, no significant phenomenon of convex, close to nature, close the door. 7.5.2 Cabinet Cabinet face paints no paint, returned to rusted, consistent color. 7.5.3 uniform indirect gap from top to bottom, slot width 1.5mm 7.5.4 adjacent Cabinet surface roughness is 0. 7.5.5 the cabinets firmly fixed, crafts beautiful. 7.5.6 Cabinet surface gauge, switch cabinet mark clear, neat, firm paste. 7.5.7 Terminal row of neat, is reliable, the appearance is clean and not damaged. 7.5.8 cables neat and clean, solid binding, binding process in appearance. 7.5