连云港市中学语育研究招标课题申报书.docVIP

课题名称 申 请 人 单 位 连云港市教育科学研究所 2009年12月 个 人 信 息 姓 名 性别 职称 手机号码 E-mail 语文教育研究成果 （从教以来发表的论文、研究的课题名录） 题 目 时 间 备 注 课题研究计划 课题结题报告纲目 学校意见 签字 （章） 年 月 日 县区教科室意见 签字 （章） 年 月 日 市教科所意见 签字 （章） 年 月 日 appearance of the weld appearance quality technical requirements of the project must not have a molten metal stream does not melt the base metal to weld, weld seam and heat-affected zone surface must not have cracks, pores, defects such as crater and ash, surface smoothing, weld and base metal should be evenly smooth transition. Width 2-3 mm from the edge of weld Groove. Surface reinforcement should be less than or equal to 1 + 0.2 times the slope edge width, and should not be greater than 4 mm. Depth of undercut should be less than or equal to 0.5 mm, total length of the welds on both sides undercut not exceed 10% of the weld length, and long continuous should not be greater than 100 mm. Wrong side should be less than or at 0.2T, and should not be greater than 2 mm (wall thickness mm t) incomplete or not allow 7.5 7.5.1 installation quality process standards of the electrical enclosure Cabinet surface is clean, neat, no significant phenomenon of convex, close to nature, close the door. 7.5.2 Cabinet Cabinet face paints no paint, returned to rusted, consistent color. 7.5.3 uniform indirect gap from top to bottom, slot width 1.5mm 7.5.4 adjacent Cabinet surface roughness is 0. 7.5.5 the cabinets firmly fixed, crafts beautiful. 7.5.6 Cabinet surface gauge, switch