PS教程：用背橡皮擦工具抠图.doc

PS教程：用背景橡皮擦工具抠图 用背景橡皮工具抠图有一定的限制，背景部分不宜过于复杂，最好是较为单一的颜色，还有主体与背景部分色差值较大。这样只需要短短几步操作就可以抠出想要的图片。最终效果 ? 原图 ? 一、打开图片，ctrl+j得到图层1，点击红圈处，创建图层2，放于图层1与背景层之间，填充白色作为检查效果和新的背景。 ? 二、按图示给出的参数，用背景橡皮擦在图层1里擦吧，注意擦的时候尽量不要松手，直到擦干净为止。 ? 三、说是擦干净为止，其实是擦不干净的，我们会看到留有许多的边缘杂色，如图示的红圈处。 ? 四、把图放大到400%，用橡皮擦工具清除掉边缘的多余杂色（画笔的大小约在5-7之间）。 五、边缘杂色清理完后的效果。 ? 六、ctrl+j复制图层1得到图层1副本，图层的混合模式滤色，不透明度40%，目的是提亮。 ? 七、点击红圈处，创建色相/饱和度调整图层，参考参数如图设置，这时一朵漂亮的小花就全部完成了抠图的任务明度40%，目的是提亮。 ? 八、看看最终效果如何。 ? 九、再换个背景看看。 the drawings, first to become familiar with the drawings, mainly about the following aspects: 1) pages of drawings and diagrams, maps; 2) a comprehensive understanding of drawing; 3) finding of design-driven dimensions (), do not resize and adjust the size; 4) questioned the drawings; 5) develop buries a construction programme and technical clarification; 6) clear corners and special treatment; 7) controlled construction drawings to verify construction scheme and design. (2) at the construction site to find subject planted area: various engineering, first on the scene to find planted area, it must first understand the curtain wall installation section, and some projects are all curtain wall, the entire project is a region-wide, only partial walls, the zone is local. (3) identify the axis positioning: positioning the drawings shown in axis compared with the actual construction site to find out exactly where the axis positioning, axis positioning function are: 1) to help determine the origin of curtain walls; 2) acceptance of the installation is accurate; 3) adjust errors, and determine the error range. (4) find anchor points: according to site to find the exact location of the axis, according to the drawings provided by the content determine the positioning point; number of anchor points shall not be less than two points. Repeated measurements determine the location points must ensure that the positioning is correct. (5) take level (level): level (minor works available in horizontal pipe), t