XRD仪器数据出方法.docVIP

现在XRD仪器数据如下图： 数据处理1.bmp 数据设置的问题如下图： 数据处理2.bmp数据设置如下图： 数据处理3.bmp ? ? 数据导出方式如下图：数据处理5.bmp数据处理4.bmp按照以上方式导出的数据就跟以前的数据模式（角度和强度数据同时显示在同一行）一致，如下图： 数据处理6.bmp 导出的以上数据格式就可以导入search-match等XRD分析软件中。 注意：数据导出的默认位置就在你所导入数据的文件夹中，所以光盘数据可以导入，但不能导出(导出时出错)。 spacing of 100mm. C, line line line nearby. D, spare wire unified terminal strip Terminal (terminal strip at the top of the vertical, horizontal terminal strip from the harness to Terminal Pai end at the beginning), length to ensure as far as Terminal and set aside. After e, form a wire harness, cable, line. When the line should be in the core wire for better identification and marking on the cards will be prepared in advance, alternate core core content for the cable numbering. F, finish line, according to the corresponding terminal locations, wire one by one from the bunch out, pulling line, should be kept parallel to each other and more. Core dark as possible, determined in accordance with specific conditions, it is required that: neat, beautiful, shapely, pleasing to the eye. 7.6.2 wiring technology, out of the core wire according to Terminal position, cut off the excess, with wire stripping pliers or electrician knife stripped of insulation, so that connection. Stripping should not damage the copper core. B, core wire on the oxide and chip-insulated electricians knife scrape. C, core processing has been completed, thread round long nose pliers in a clockwise direction. Circle with the screw in the direction of spin in the same direction, circle should be appropriate, it is best to slightly larger than the screws, bent round the circle and the length of root and appropriate so set screw is screwed on tight. D, when on the crimp-type terminals when wiring, threads do not have to bend. Insulating part should be careful not to press it into a Terminal, and make the loop doesnt make sense and to prevent bad head crimping, fell down, causing an open circuit. After wiring, may be tried. E,