手机充电器的模具设计大学课程内容.docVIP

学号：24101900423 南湖学院 毕业设计 题目:滑轮的注塑模具设计 届 别 14届 系 别 专 业 指导老师 丁超义 职 称 讲师 完成时间 2014年5月 摘 要 关键词：Abstract This article is about the mold design of mobile phone charger, the entire design process, I have the entire design process to a comprehensive introduction about the injection mold. In the design process,manufacturability analysis of plastic parts, first consider the technology of plastic parts is in accordance with the mold design requirements; Then carries on the analysis of mould structure, mainly including the plastic parts processing technology and production efficiency requirements. The technology requirement is to ensure that the geometry and dimension tolerance and surface roughness,and production efficiency requirement is of low cost and high efficiency, long service life, convenient maintenance, safe. in turn, including parting surface selection, location and cavity number and layout, pouring system, exhaust, molding parts, demoulding mechanism, guide mechanism, temperature control system, the classification mechanism, overall design and selection of die set injection molding machine;According to the in front of the plastic parts, die structure analysis，CAD, PRO / E and other drawing software to draw the mold parts, spare parts, assembly drawings, three-dimensional map,then subjected to analysis mold during operation, so as to arrive the feasibility of the mold, and then summarize this design. Key words：Injection mold; Plastic analysis; Die design; Pro/E; CAD 第一章 绪论 1 1.1 前言 1 1.2 对注塑模具 1 1.3 设计的意义目的 2 第二章 手机充电器外壳工艺性设计 3 2.1 塑件工艺性分析 3 2.2 塑件的材料分析 4 2.3 外壳的性能描述 5 2.4 注射机的初选 6 第三章 模具的结构设计 8 3.1 分型面的选择和型腔数量和布局的确定 8 3.1.1 分型面合模方向的选择 8 3.1.2 模具的基本结构选择 9 3.1.3 型腔数量和布局的确定 10 3.2 浇注系统的设计 11 3.2.1 主流道设计 11 3.2.2 分流道设计 12 3.2.3 浇口设计 13 3.2.5 冷料穴设计 14 3.3 成型零件设计 14 3.