亚硫酸内酯型乳化剂制备及粘土沥青乳化悬浮体系性能评价.docVIP

  • 2
  • 0
  • 约6.68千字
  • 约 8页
  • 2016-10-19 发布于重庆
  • 举报

亚硫酸内酯型乳化剂制备及粘土沥青乳化悬浮体系性能评价.doc

亚硫酸内酯型乳化剂制备及粘土沥青乳化悬浮体系性能评价

亚硫酸内酯型乳化剂的制备及粘土沥青乳化悬浮体系性能评价 栾玉娜1,杨庆鸿2,任春燕3,王越4,王梓桐5,张荣明1( (1.东北石油大学化学化工学院应用化学实验室,黑龙江 大庆 163318; 2.大庆油田有限责任公司第一采油厂实验大队,黑龙江大庆 163001; 3. 大庆油田有限责任公司第二采油厂第三作业区地工队,黑龙江大庆 163310; 4. 渤海钻探工程技术研究院,天津300280; 5.大庆油田有限责任公司第八采油厂大庆 1635142-亚硫酸)乙基二甲基铵(DMA12,DMA14,DMA16,DMA180.002 mol/L的DMA18与沥青间的界面张力最低,为0.079 mN/m,起泡比达到200%,接触角为108.19o。当m粘土:m沥青=4.5:1时,休止角为29.33°,二者混合最均匀。当粘土沥青乳化悬浮体系各组分质量比m粘土沥青:mDMA18:m聚乙烯醇=100:4:1时,所制备的乳化悬浮体系七天后仍没有出现析水现象,比较稳定,适用于封堵地层。 关键词:乳化剂;粘土沥青乳化体系;封堵地层 The Preparation of Emulsifier of sulfurous acid lactone and Performance Evaluation of Clay-asphalt System Luan Yu-na1, Yang Qing-hong2, Ren Chun-yan3, Wang Yue4, Wang Zi-tong5, Zhang Rong-ming1* (1 Laboratory of Applied Chemistry, College of Chemical Engineering, Northest Petroleum University, DaqingHeilongjiang 163318, China;The First Production Plant of Daqing Oil Field Co., DaqingHeilongjiang 163001, China;The Second Production Plant of Daqing Oil Field Co., DaqingHeilongjiang 163310, China; Engineering Technology Research Institute of Bohai Drilling, Tianjin 300280, China; Oil Recovery Plant No.8, Daqing Oilfield Corp. Ltd., Daqing, Heilongjiang 163514, China. ) Abstract: The corresponding Polyalkyl ethyl dimethyl ammonium were synthesized by dodecyl dimethyl tertiary amine(DMA12), DMA14, DMA16, DMA18 reacted with thionyl chloride, respectively. According to FT-IR spectra, it was concluded that four kinds of emulsifier were prepared successfully. The properties (ultralow interfacial tension, foamability and contact angle) of the four emulsifiers were measured. Then choose the most appropriate one. The mass ratio of clay and asphalt and the dosage of emulsifier and suspending agent were determined by experiments, then prepared the clay asphalt composite suspension system. The results showed that octadecyl (2-sulfite) ethyl dimethyl ammonium exhibited the lowest ultralow interfacial tension of 0.0079 N/m, foamability of 300%, contact angle of 108.19o and excellent emulsibility at n=0.002 mol/L. When ma:mc

文档评论(0)

1亿VIP精品文档

相关文档