NIKE SOP for Shoetown.ppt

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * Troubleshooting Pot life Trouble Workers could forget the time of changing adhesive (pot- life), for example, if they are busy. Solution Mark the time to change adhesive on the bowl or dispenser so that workers can recognize the time and use adhesive properly. * Troubleshooting Coating weight Trouble As workers get familiar with water-based adhesive, they follow application method of water-based type, applying thinly, even when applying solvent-based type. So bonding problem may caused due to insufficient coating. Solution The solids content of water-based adhesive is much higher than that of solvent-based type. For example, water-based PU contains 50% of solids while solvent- based type has 20%. Therefore, supervisors should train their employees to differentiate coating amount of water- based type from solvent-based type. * Troubleshooting Application tool Trouble Excessive amount of adhesive by using a thick brush causes pudding on the surface of substrate and makes brush hard. Solution Use an appropriate-thickness brush considering its purpose. * Troubleshooting Contamination Trouble If using a cleaner not refreshing or changing regularly, it could be contaminated by the application tool which has contacted with contaminated substrate. Then, certain contaminants may concentrate in the cleaner. Solution Refresh or change with new cleaner regularly to minimize contamination of cleaner in use. Change an application tool regularly by marking exchanging time on a deposit case. * Troubleshooting HMA applicator Trouble When running HMA applicator with small amount of hot- melt in the thank, or leaving the applicator heat at high temperature, melted adh