Training-9-RPPCB-Roland-0511.pptVIP

Basic information about the RPPCB The rapid PCB system is a CAM system, a peripheral equipments system for the CAD/EDA. It can do many kinds of materials processing including drilling,engraving and cutting etc.,and combines many advanced technology so far. Environmental protection spirit is fulfilled in the whole processing. The prototyping machines of Proto series,together with the PTH(plated through hole) equipment and the multi layers pressor,double-sides and multilayer board can be easily made. Processing Principle CAM data(Gerber,Excellon,DXF,etc.) from CAD/EDA software ? CircuitCAM calculating the isolation groove track ? BoardMaster driving the plotter to work on the materials. Drilling on the materials; Plating the through holes; Engraving the isolation tracks on bottom side; Turning the material over to engraving the isolation track on top side; Cutting outside of the PCB. Operating Steps 2,According to the shortcut buttons, config the Contour Routing and run; set Break Tab; set Rubout Layer; doing the Design Rule Check ; set Insulating and Run Insulating; finally export the processing data of *.LMD. 3,Importing *.LMD to BoardMaster, then the maching data displayed. Following the order of the PHASE menu to work :Drillplated?(Plating through holes for galvanic plating device) ?MillingBottom?MillingTop?CuttingOutside. Making 4 layers PCB Making 4 layers PCB By Roland LPKF (Tianjin) Laser and Electronics Co. Ltd. Instruction of the Operation and Maintenance of the LPKF Papid PCB Prototyping System 1, Importing the Gerber,excellon or DXF data to CircuitCAM. Doing some modification when necessary,e.g. data format,deleting unuseful data and layers assigning. Learning outline 1 1- Hardware Connection and setting 2- Software installation of BoardMaster and CircuitCAM 3- EDA software’s CAM Data format,Gerber and its output CircuitCAM 4- Importing Gerber and DXF etc.,Batch import 5- Menu 6- Apeture/Tool Modifying 7- Layout data processing,including -co