sketch.ppt

Copyright DASSAULT SYSTEMES 2002 Sketcher Course Presentation Objectives of the course In this course you will learn how to sketch, constrain, and edit 2D profiles. These profiles are then used to generate solids and surfaces Targeted audience New users Prerequisites CATIA Basics Table of Contents (1/3) Introduction to CATIA Sketcher p.6 Workbench Presentation p.7 Sketching Simple Profiles p.17 The Sketcher Work Modes p.18 Profiles p.26 Points p.29 Lines p.33 Spline p.37 Circles and Arcs p.41 Conics p.47 Axis p.53 Sketching Pre-De