外文资料李青.docVIP

ForewordThe mold industry is an important part of the manufacturing sector, and has broad market prospects. Mold around the world annual production value of about $ 65 billion, the mold of Chinas annual production value of about $ 4 billion, it is estimated that by 2005 Chinas mold production value will reach 46 billion yuan. 30% of the general mold in China, more than half of the high-grade mold dependent on imports (including injection mold a large proportion). Thus, the mold (injection mold) Manufacturing backward in a way to block the development of Chinas manufacturing bottleneck. Development and introduction of advanced manufacturing technology is to change the injection mold industry in China is relatively backward and rapid growth in market demand, an important way.Advanced manufacturing technology, manufacturing will continue to assimilate the results of information technology and modern management techniques, and applied to product design, processing, testing, management, sales, use, service and even the recovery of manufacturing process to achieve high quality, efficient, low consumption, clean, flexible production, improve the general term of the capacity and competitiveness of the manufacturing technology to adapt to dynamically changing market. Advanced manufacturing is rapidly changing the product mix of the traditional manufacturing industries and production patterns, injection mold manufacturing industry is no exception.The characteristics of an injection mold manufacturing??⑴ cavity and the core was a three-dimensional surface. External and internal shapes of plastic parts directly from the cavity and core forming these complex three-dimensional surface machining difficulty, especially the forming surface within the cavity of the blind pass processing, traditional processing methods, not only requirements of high technical level of workers and auxiliary fixtures, cutting tools, and long processing cycle.??(2) accuracy and high surface quality