煤矿采掘工作面J616顶板矿压在线监测管理考核办法A.docVIP

煤矿采掘工作面KJ616顶板矿压在线监测管理考核办法A 为加强管理， 把离层传感器A、B基点的猫爪用安装杆安装到规定的位置，先装A深基点到位后拉紧钢丝线缆，然后安装B浅基点到位后拉紧钢丝线缆（A为10M线圈安装至打孔最深处深于或略深于锚索锚固端，B为5M线圈安装深度深于或略深于锚杆锚固端）。 把传感器的固定杆安装到安装孔内并固定好（托盘接触顶板，必要时可以剪断局部锚网），把两基点的钢丝线拉紧并将托盘下部紧固螺钉顺时针紧固，把多余的钢丝线剩下30cm左右后剪断。 把传感器线缆接到通信主线路中（红、白、蓝、绿各颜色相对应）。 二：锚杆应力传感器： 锚杆应力传感器安装位置锚杆外露长度需大于等于150MM 锚杆端头先安装一片W钢带/托盘（铁饼），锚杆应力计的平整端面紧贴W钢带/托盘（铁饼），带球型凹槽的端面放入球形盖，后用螺母拧紧； 锚杆必须用力矩扳手紧固，紧固锚杆螺母应没（mo）过丝扣（俗称没丝，锚杆丝扣应外露于螺母），预紧力不低于20KN，显示窗屏幕可显示KN数。 接线： 接线盒中的线必须用橡胶压线圈压紧，压线圈外放入垫片，然后用扳手拧紧最外面的压线螺母； 接线盒里的线必须颜色对应并按照接线盒内线序方向接线，剥线时裸露少量端头，用压线螺丝压紧，确保线头不接触，以免引起短路。 离层仪、锚杆应力传感器成对安装时应至少8对增设一组KDW28-18电源 增设电源接线： 电源出线只用红白线，剪掉蓝绿线头，红白线与后面信号线中的红白线相连接，确保只为后面传感器供电，信号线前后端头蓝绿相连，确保信号传输，前端信号线的红白线头剪掉。 恒安电子煤矿信息中心 showing a relatively independent form. The old town and the road network has been developed along the South, road networks are well-shaped grid structure. The nanxi area, the minjiang River area, dvn group and other area roads has not developed to a certain size showing a relatively independent form. The old town and the road network has been developed along the South, road networks are well-shaped grid structure. The nanxi area, the minjiang River area, dvn group and other area roads has not developed to a certain size1 showing a relatively independent form. The old town and the road network has been developed along the South, road networks are well-shaped grid structure. The nanxi area, the minjiang River area, dvn group and other area roads has not developed to a certain size