500kV电缆线路工频参数的计算与分析_王晓彤.docxVIP

DOI:10.13335/j.1000-3673.pst.2013.08.040第 37 卷 第8 期电 网 技术Vol. 37 No. 82013 年 8月Power System TechnologyAug. 2013文章编号：1000-3673（2013）08-2310-06中图分类号：TM 751文献标志码：A学科代码：470·4051500 kV 电缆线路工频参数的计算与分析王晓彤 1，项祖涛 1，班连庚 1，蒋卫平 1，钱康 2，牛涛 2（1．中国电力科学研究院，北京市 海淀区 100192； 2．江苏省电力设计院，江苏省 南京市 211102）Calculation and Analysis on Power-Frequency Parameters for 500 kV Cable LinesWANG Xiaotong1, XIANG Zutao1, BAN Liangeng1, JIANG Weiping1, QIAN Kang2, NIU Tao2(1. China Electric Power Research Institute, Haidian District, Beijing 100192, China;2. Jiangsu Electric Power Design Institute, Nanjing 211102, Jiangsu Province, China)ABSTRACT: Utilizing EMTP and taking a 500 kV XLPE cable line with length of 8.7 km for example, the power frequency phase parameters and sequence parameters of this cable line are calculated and analyzed. Research results show that different arrangements of cable lines have no effect on capacitance matrix, and the zero-sequence capacitance is equal to the positive-sequence capacitance; if the cable lines are not transposed, the electromagnetic unbalance factor of cable line will be increased after the cross-connection of metal sheathes; and under the transposition of cable lines when the metal sheathes are cross-connected, the electromagnetic unbalance factor is very low, thus the cable line can be regarded as a balanced line. When both ends of metal sheathes are grounded, the cross-connection of metal sheathes will increase the positive-sequence impedance of cable line while the zero-sequence impedance is not impacted; the ground resistance at both end of cable line significantly impacts the zero-sequence impedance, however the ground resistance of cable units located in the middle position of the cable line slightly impact the zero-sequence impedance.衡度0引言目前，220 kV 电缆线路在上海、北京、天津等 地已有较多应用，而 500 kV 电缆线路也有一些应 用，如虹杨－杨行 500 kV 输电工程(电缆部分长 12 km)、上海世博站 500 kV 输电工程(电缆部分长 15 km)等[1-4]。国内最长的 500 kV 电缆线路是广 东－海南 500 kV 海底电缆输电工程(电缆部分长 31 km)[5-8]。这是中国第 1 个 500 kV 超高压、长距 离、较大容量的跨海