RRC 详解.pptxVIP

A304 Test cases Overview SunQiangRRC Connection Establishmentnetwork rejects RRC connection1718-Device behaviour upon receiving RRC Connect Request Reject - Network Busy during?PS Service Request - 3G UE1Prior to starting the test, configure the device for any push type of data application, such as Blackberry email, Active Sync email, PUSH email, Facebook, Twitter , etc, etcNOTE : If the device does not support these types of applications, then during the test initiate a Browser session2Enable 3G cell at target power level and 2G cell at very low power and power on the UE3Confirm that the UE selects 3G and then registers4Ramp 2G cell to target power level5Confirm that the previously configured application attempts to establish a PDP Context (See note in Step 1) but the RRC CONNECTION REQUESTS are rejected with Cause = NETWORK BUSY and a Wait Time = 15s6Monitor the UE behavior on both 2G and 3G cells for the duration of the test and and record the number of RRC Connection attempts.Reselection and registration onto 2G is allowed and does not constitute a failure7Confirm that the total number of RRC Connection requests on 3G does not exceed 240 during the test duration.MAX-ATTEMPTS = 240SEV-1 : if Count ≥ MAX-ATTEMPTS + 21%SEV-2 : if Count ≥ (MAX-ATTEMPTS + 11%) AND ≤ (MAX-ATTEMPTS + 20%)SEV-3 : if Count ≥ (MAX-ATTEMPTS + 1%) AND ≤ (MAX-ATTEMPTS + 10%)8Determine the pattern of RRC CONNECTION REQUEST retries over the duration of the test and confirm that there is at least a back-off algorithm implemented.NOTE a continuous bombardment of requests does not constitute a back-off algorithm9At the end of the test duration, deactivate all cells and power off the UENameParametersShortDescriptionReferenceRRC CONNECTION REQUESTMessage TypeM指示本条消息类型3GPP TS 25.331Predefined configuration status informationM取值为True表明UE已经预先配置和小区广播信道上的通知信息相同3GPP TS 25.331Initial UE identityMRRC连接建立时向网络提供唯一的UE标识3GPP TS 25.331Establishment causeMRRC建立原因3GPP TS 25.331CN domain identityM区分核心网域，取值范围{CS，PS