51温度湿度c语言代码概述.doc

#ifndef __TOU_H__//如果没有被编译过 #define __TOU_H__//那么标记为编译过 #includereg52.h #include intrins.h #include math.h #includestring.h #define uint unsigned int #define uchar unsigned char enum {TEMP,HUMI}; sbit DATA = P2^5;//温湿度传感器位定义 sbit SCK = P2^4; void s_connectionreset(void);/******** SHT11函数声明 ********/ char s_measure(unsigned char *p_value, unsigned char *p_checksum, unsigned char mode); void calc_sth10(float *p_humidity ,float *p_temperature); float calc_dewpoint(float h,float t); #endif//结束#ifndef，如果已经编译过就跳过之间的部分 uchar code table1[]=00:00:00; uchar code table2[]=00:00:00RH:00.0; sbit shui1=P1^0; sbit shui2=P1^1; sbit shi_s1=P1^2; sbit shi_s2=P1^3; sbit shi_s3=P1^4; sbit led=P1^6; sbit sound=P1^7; sbit lcden=P2^2; sbit lcdrw=P2^1; sbit lcdrs=P2^0; sbit relay=P2^3; sbit s1=P2^7; uchar data disdata[4]; uchar num,count,s1num; char shi,fen,miao,shi1,fen1,miao1; uint bian,i,j; void delay(uint z) { uint x,y; for(x=z;x0;x--) for(y=110;y0;y--); } //SHT11程序（SHT11.c）： #define noACK 0 //继续传输数据，用于判断是否结束通讯 #define ACK 1 //结束数据传输； //地址 命令 读/写 #define STATUS_REG_W 0x06 //000 0011 0 #define STATUS_REG_R 0x07 //000 0011 1 #define MEASURE_TEMP 0x03 //000 0001 1 #define MEASURE_HUMI 0x05 //000 0010 1 #define RESET 0x1e //000 1111 0 //写字节程序 char s_write_byte(unsigned char value) { unsigned char i,error=0; for (i=0x80;i0;i=1) //高位为1，循环右移 { if (ivalue) DATA=1; //和要发送的数相与，结果为发送的位 else DATA=0; SCK=1; _nop_();_nop_();_nop_(); //延时3us SCK=0; } DATA=1; //释放数据线 SCK=1; error=DATA; //检查应答信号，确认通讯正常 _nop_();_nop_();_nop_(); SCK=0; DATA=1; return error; //error=1 通讯错误 } //读字节程序 char s_read_byte(unsigned char ack) { unsigned char i,val=0; DATA=1; //释放数据线 for(i=0