Doubl Surface dressing 双表处施工英文版.docVIP

UPGRADING PERAMIHO JCT TO MBINGA ROAD TO BITUMEN STANDARD Method Statement for Double Surface Dressing Personnel: Team leader 1 (Wang Shizheng) Mr. Zhang will be responsible for the works and all instruction issued on site could be directed to him. He has a good command of English. He is able to brief in detail on this method statement before the works commence. 1. Chainman 3 2. Surveyor 1 3. Chip Spreader Operator 1 4. Rubber Roller Operator 2 5. Mechanical Sweeper Operator 1 6. Dump Truck Driver 4 7. Bitumen Distributor Operator 1 8. Transport Light Truck Driver 1 9. Pick-up Driver 1 10. Flagman 2 11. Experienced Labor 8 B. Equipment 1. Chip Spreader 2 2. Mechanical Sweeper 1 3. Rubber Roller 2 4. Bitumen Distributor 1 5. Dump Truck 4 6. Transport Light Truck 1 7. Pick-up 1 Two thousand meters of half lane width are expected to be placed each day, that is to say, one thousand meters of full lane width per day. C. Method Statement Layer pavement method is adopted for double surface dressing. Usually by this method, a layer of bitumen shall be first spread followed by the spreading of a layer of aggregate. The construction procedure of double surface dressing is indicated below: The details of procedure as following: Preparation of surface Ahead of double surface dressing construction, clean surface should be prepared so as to expose the majority of aggregate. Meanwhile, bumpy and rough road sections must be repaired and leveled. The weatherglass will be used to monitor the temperature of the road surface, whenever the temperature of the road surface falls below the temperature that be depicted in section 4304(a) of the Standard Specification for Road Works, no blinder shall be sprayed. No bituminous work shall be done during foggy or rainy weather. Where newly constructed base or shoulder areas are to be sealed, the surfaces shall be checked for compliance with the surface tolerances and all other requirements specified. Any portions that do not meet t