positon Settings.docVIP

position Settings, can prevent the considerable temperature stresses measures should be taken. Should be done when the heating temperature exceeds 45 ℃, temperature stress calculation. 10, steel reinforced concrete composite structures, dealing with steel preheated before pouring concrete, preheat temperature should be greater than the concrete into the die temperature, preheating method according to the architectural engineering winter construction regulations JGJ/T104 related provisions in section 6.5. 【 2 】 heating, can mix, transportation and casting of the raw materials for the concrete 1, the raw materials of concrete heating should adopt the method of heating water. When heating water still cannot meet the requirements, can be carried out on the aggregate heated. When the temperature of the water and aggregate still can not meet the requirement of the computation, can improve the water temperature to 100 ℃, the cement shall not direct contact with water of above 80 ℃. 2, appropriate USES water heating steam heating, electric heating, soda, heat transfer or other heating methods. Tank or pool volume and water temperature should be able to meet the requirements of continuous construction. 3, sand heating should be performed before the opening, the heating should be uniform. When heating temperature hopper is used, should be equipped with two, alternate heating use. Each bucket capacity can according to mechanical loading height and wall thickness requirements for design, each bucket capacity should not be less than 3.5 m3. Ready-mixed concrete with sand, should save enough material in advance, to have the heating facilities insulation sealing material storage tents (room) or warehouse. Set aside. 4 not directly heated, cement, cement bags before use should be transported into the greenhouses in the store. 5, in the process of transportation and casting of concrete temperature and heat preservation material covered, should press winter construction period