材控专业英语-5.Plastics_forming_and_molds资料.ppt

5.2.3 Construction of a Compression Mold Words and terms: Asymmetrical 不对称的， Flash 毛刺，飞边， Material residue 料渣 Ejector pin 推杆，顶杆 Multitude 大量，众多 5.2.3 Construction of a Compression Mold A compression mold basically consist of an upper and a lower part. In normal cases the lower half is fitted to the table of the press and the upper half to the ram. 压模基本上包含上半部分和下半部分。通常把模具的下半部分安装在工作台上，上半部分安装在压头上。 Both mold halves are guided by hardened dowel. Asymmetrical parts cause large one sided pressure loads to be exerted on the mold. They require compensation through special guides. 这两部分都是由坚硬的榫钉为导向的