大学毕业论文---tsc静止无功补偿提高系统电压理论研究.docVIP

摘要 近年来，由于电网容量的增加，对电网的无功要求也与日增加，同时对电能质量的要求也越来越高。传统无功补偿装置很难达到单位功率因数的补偿，电网无功功率不平衡将导致系统电压的巨大波动，严重时会导致用电设备的损坏，出现系统电压崩溃和稳定破坏事故。TSC是目前广泛使用的无功补偿方式，具有结构简单、费用较低的优点; 论文首先介绍了无功功率补偿的意义和现状，无功功率的作用。介绍了TSC基本结构和原理，建立了的数学模型，对稳定性进行了分析。其次，在分析TSC特点后，确定了整体控制策略:TSC以无功功率为主要控制目标，而大部分无功功率由TSC补偿，本文重点介绍TSC静止无功补偿稳定系统电压的研究。为验证本文研究的控制策略的有效性， 在MATLAB/Simi LINK环境下对TSC进行了仿真研究。对TSC系统进行了设计，仿真。结果验证了该控制算法的有效性，能增加系统的稳定性，减少电容器动作的次数。通过SIMULINK建立了TSC仿真模型，对仿真波形图进行了分析，结果表明TSC型静止无功补偿在提稳定系统电压方面能满足要求，显示出该无功补偿方式具有较大的应用价值。 关键词： 无功功率 静止补偿 稳定电压 Abstract In recent years, due to the increase of power capacity, the reactive power demands of electricity, and with increasing more and more is also high quality requirements. Traditional reactive compensation device is difficult to achieve unit power factor compensation, grid reactive power imbalance will cause the system voltage fluctuation, the huge will cause serious damage to the electric equipment, appear system voltage collapse and stable destruction accidents. TSC is currently the extensive use of reactive compensation methods, has simple structure, low cost advantages; It firstly introduces the significance of power compensating reactive power and status quo, and reactive power function. Introduces the basic principle and structure, TSC, the mathematical model was established for stability is analyzed, and discusses the method of harmonic restrain themselves. Secondly, in the analysis, determines the TSC characteristics in overall control strategies: TSC of reactive power as the main control goal, but most of the reactive power compensation by the TSC, this paper puts emphasis on the introduction of TSC static reactive compensation stable system voltage research. In order to validate this paper studies the effectiveness of the control strategy, In MATLAB/Simi LINK environment TSC simulations were performed. TSC system design, the simulation. Results verify the effectiveness of the control algorithm, can increase the stability of system, redu