03ANSYS13.0Workbench结构非线性培训概述剖析.ppt

A change of status that causes an abrupt change in stiffness is another common cause of nonlinear behavior. For example: A cable can change status from slack to taut Two parts in an assembly can come into contact Machining can remove prestressed material ANSYS Details: Internally, the different contact formulations are as follows: For Simulation, the default is pure Penalty. “Normal Lagrange” is actually Lagrange multiplier on normal, penalty on tangent Lagrange multiplier method on both normal and tangent is not currently available in Simulation GUI “MPC” is only available for bonded co