《土木工程毕业设计(论文)_南京市某高校综合楼设计计算书》.docx

目 录1 工程概况11.1 工程总体概况11.2 工程设计资料11.3 材料使用12 结构选型和布置22.1 确定结构体系、柱网与层高22.2 框架结构的计算简图22.3 梁、柱截面尺寸、板厚的初步确定23 框架侧移刚度的计算43.1线刚度的计算43.2 柱的侧移刚度计算54 横向水平荷载作用下框架结构的内力和侧移计算74.1 重力荷载统计74.2 横向水平地震荷载作用下的内力和侧移计算95 竖向荷载作用下框架结构的内力155.1 竖向恒载计算155.2 竖向活载计算175.3 内力计算196 内力组合276.1 柱的内力组合276.2 梁的内力组合447 梁柱截面设计507.1 框架梁设计507.2 框架柱设计628 基础设计818.1荷载计算818.2柱A(D)基础形式的确定818.3柱B基础形式的确定849 楼板设计889.1 楼面板设计889.2 屋面板设计9410 楼梯设计9910.1 踏步板的计算9910.2 梯段梁的计算10010.3 平台梁的计算10210.4 平台板的计算103参考文献104致 谢105南京市某高校综合楼设计摘 要本设计是高校综合楼设计。建筑面积为2763.5m2，层数四层，总体高度为15.3m。根据综合楼的功能要求及所处地区决定采用钢筋混凝土框架结构。结构采用纵向框架承重体系，竖向荷载包括恒载和活载，都采用分层法进行内力分析。水平荷载，仅考虑水平地震荷载的作用，采用D值法和反弯点法进行内力分析。考虑不同情况下的内力组合后，得出最不利截面的控制内力，依此进行配筋计算。 本课题的设计计算书包含：工程概况、结构选型和布置、框架侧移刚度的计算、横向水平荷载作用下框架结构的内力和侧移计算、竖向荷载荷载作用下框架的内力、梁柱截面设计、基础设计、楼板设计、楼梯设计。关键词：框架结构；荷载计算；内力分析；配筋计算The Design of a comprehensive building in a university of NanjingAbstractThis design is a complex building design universities. Construction area of 2763.5m2, four layers, the overall height of 15.3m. According to the functional requirements and their locations, the decision to adopt comprehensive building of reinforced concrete frame structure. Longitudinal frame bearing structure of the system, including the vertical load dead load and live load, are analyzed by internal force stratification. Horizontal load, consider only the horizontal seismic load effects, internal force analysis using D value method and the inflection point method. After considering a combination of internal forces under different circumstances, produce the most unfavorable internal force control section, and so were Reinforcement.The design calculation of this subject includes: The survey of the program, The?selection?and arrangement?of?the?structure,The calculation of frame lateral?stiffness,?The internal forces and drift?calculation of frame structures?under?lateralhorizontal loads?,?The Internal force of the Frame Structure under thevertical?loads?,The design of?beam and column?,?The design of the base,?The design of the floo