MF_RC22_射频识别参考程序注释new.docVIP

MF RC522 射频识别参考程序注释 串口读取的数据//------------------------------------------ ucAddr = ((Address1)0x7E)|0x80;//变化成有效的地址形式，最低位为0，最高位为1时候时，从MFRC522读出数据，最低位为0，最高位为0时候时，往MFRC522写数据，参考39页 // 读SPI数据 //------------------------------------------ unsigned char SPIReadByte(void) { unsigned char data SPICount;// Counter used to clock out the data unsigned char data SPIData;SPIData = 0; for (SPICount = 0; SPICount 8; SPICount++)// Prepare to clock in the data to be read {SPIData =1;// Rotate the dataCLR_SPI_CK; nop();nop();// Raise the clock to clock the data out of the MAX7456if(STU_SPI_MISO){SPIData|=0x01;}SET_SPI_CK; nop();nop();// Drop the clock ready for the next bit }// and loop back return (SPIData);// Finally return the read data } //------------------------------------------ // 写SPI数据 //------------------------------------------ void SPIWriteByte(unsigned char data SPIData) { unsigned char data SPICount;// Counter used to clock out the data for (SPICount = 0; SPICount 8; SPICount++) {if (SPIData 0x80){SET_SPI_MOSI;}else{CLR_SPI_MOSI;} nop();nop();CLR_SPI_CK;nop();nop();SET_SPI_CK;nop();nop();SPIData = 1; }}///////////////////////////////////////////////////////////////////// //功 能：寻卡 //参数说明: req_code[IN]:寻卡方式 //0x52 = 寻感应区内所有符合14443A标准的卡 //0x26 = 寻未进入休眠状态的卡 //pTagType[OUT]：卡片类型代码 //0x4400 = Mifare_UltraLight //0x0400 = Mifare_One(S50) //0x0200 = Mifare_One(S70) //0x0800 = Mifare_Pro(X) //0x4403 = Mifare_DESFire //返 回: 成功返回MI_OK ///////////////////////////////////////////////////////////////////// char PcdRequest(unsigned char data req_code,unsigned char *pTagType) { char data status;unsigned int data unLen; unsigned char data ucComMF522Buf[MAXRLEN];ClearBitMask(Status2Reg,0x08);//清除MRCrypto1on，要用软件清零 WriteRawRC(BitFramingReg,0x07);//startsend=0,rxalign=0,在FIFO中存放的位置，TXlastbit=7 SetBitMask(TxControlReg,0x03);//TX2rfen=1,TX1RFen=1,传递调制的13.56MHZ的载波信号 ucComMF522Buf[0] = req_code; status=PcdComMF522(PCD_TRANSCEIVE,ucComMF522Buf,1,ucCo